Ion-beam sputtering of NiO hole transporting layers for p-i-n halide perovskite solar cells

Abstract

Ion-beam sputtering offers significant benefits in terms of deposition uniformity and pinhole-free thin-films without limiting the scalability of the process. In this work, the reactive ion-beam sputtering of nickel oxide has been developed for the hole transporting layer of a p-i-n perovskite solar cells (PCSs). The process is carried out by oxidation of the scattered Ni particles with additional post-treatment annealing regimes. Using deposition rate of 1.2 nm/min allowed growth of very uniform NiO coating with the roughness below 0.5 nm on polished Si wafer (15x15 cm2). We performed a complex investigation of structural, optical, surface and electrical properties of the NiO thin-films. The post-treatment annealing (150-300C) was considered as an essential process for improvement of the optical transparency, decrease of defects concentration and gain of the charge carrier mobility. As result, the annealed ion-beam sputtered NiO films delivered a power conversion efficiency (PCE) up to 20.14%, while device without post-treatment reached the value of 11.84%. The improvement of the output performance originated from an increase of the short-circuit current density (Jsc), open circuit voltage (Voc), shunt and contact properties in the devices. We also demonstrate that the ion-beam sputtering of NiO can be successfully implemented for the fabrication of large area modules (54.5 cm2) and PSCs on a flexible plastic substrate (125 microns).

Abstract: arXiv descriptive metadata (CC0). Thank you to arXiv for use of its open access interoperability. This service was not reviewed or approved by, nor does it necessarily express or reflect the policies or opinions of, arXiv.