Cross-Layer Co-Design of Low-Latency Stateful Logic Adders with Printed Memristors

Abstract

Data movement between memory and processing units remains a major bottleneck in data-centric systems. Memristive Stateful Logic (SL) addresses this problem by performing Boolean operations directly on stored resistive states. However, arithmetic efficiency depends jointly on the device-supported logic primitive set, the dependency structure of the resulting operation sequence, and its mapping to datapath architectures. While prior designs typically optimize device, logic, and architecture layers separately, we jointly consider them to co-design a stateful adder. We experimentally demonstrate a mixed MAGIC and FELIX logic primitive set on printed Electrochemical Metallization (ECM) memristors and derive a full adder sequence optimized for inter-bit carry propagation. Mapping this sequence to bit-serial, bit-parallel, and bit-pipelined datapaths reduces the latter two to 2n+6 cycles for an n-bit addition. For 32-bit addition, this requires 60-88% fewer cycles than prior SL adders. Across four representative workloads, we achieve 3.7x-16.4x speedup over prior. These results show how cross-layer co-design can translate into improved workload-level performance.

Abstract: arXiv descriptive metadata (CC0). Thank you to arXiv for use of its open access interoperability. This service was not reviewed or approved by, nor does it necessarily express or reflect the policies or opinions of, arXiv.